One of my most rewarding kitchen adventures has been learning how to make cake pops. I always know that if I want to let my baking imagination run wild, I can just start with a cake pop recipe and see where it takes me! The possibilities are endless.
That’s why today I am sharing with you a basic cake pop how to. If cake pops are new to you or you have tried them in the past and never gone back, this cake pop recipe is the perfect place to start. With a little step-by-step guidance, cake pops can be easy!
Cake Pop Supplies
To make cake pops, you will need:
– A box cake mix and ingredients to make the cake
– A can of frosting
– Lollipop sticks or colorful paper straws
How to Make Cake Balls
To create cake pops, you need to start by making cake balls that you will later apply to lollipop sticks. The easiest way to make cake balls is to follow the directions on a box of cake mix. I usually deviate from the directions in one way, I use half the amount of oil. This helps create the right consistency for your cake balls. If you are not a fan of boxed cake mix, you can also bake a homemade cake (more power to you!).
After you bake your cake, let it cool completely and… get ready for destruction! Your goal is to crumble your cake into fine crumbs. You can do this one of two ways:
1) Use your hands. Put chunks of your cake into a large mixing bowl and use your hands to crumble it into a pile of fine crumbs. If you use this method, I suggest cutting off the hard edges of your baked cake.
2) Use a food processor. Put chunks of your cake into a food processor and pulse it into fine crumbs. Move the crumbs into a large mixing bowl.
Add a small amount of frosting to your cake crumbs and thoroughly combine using your hands. Continue to add small amounts of frosting until your crumb mixture becomes the consistency of clay.
Helpful Hint: Some cake pop recipes call for you to add an entire container of frosting. I have found that this is way too much. I generally add 1/3 to 1/2 cup of frosting. A good rule of thumb is to start with a small amount and then add more frosting as needed.
Once you have created your “dough”, you can begin rolling your cake balls. I like to use a stainless steel coffee scoop to portion out my cake mixture so that all my cake balls are the same size, about 1.25″. Roll the mixture in the palm of your hand to create round cake balls.
Set your cake balls onto a parchment lined baking sheet or plate and put them in the freezer or refrigerator. If you have time, keep the cake balls in the fridge for a few hours until chilled. If this just doesn’t fit into your busy schedule, about 15 to 20 minutes in the freezer will do the trick. Do keep in mind that making cake pops is a temperature sensitive process. Putting cake balls in the freezer may make them too cold for dipping, so you will need to let them sit for a few minutes after removing them.
How To Turn Your Cake Balls Into Cake Pops
Helpful Hint: For the next few steps, work with just a handful of cake balls at a time, rotating them in and out of the fridge. This will ensure that you always have chilled cake balls ready to go. This is where it comes in handy to have a few petite cake pop stands to rotate around!
Microwave your candy melts in a bowl on low power for 30-seconds at a time. Stop and stir after each 30-second interval then repeat until the coating is completely melted. Do not overheat the candy melts or your coating will become lumpy. If the coating is too thick, add a small amount of vegetable oil to thin it out.
Dip the end of a lollipop stick into the melted coating and then into a cake ball, gently pushing until the stick is about half way through the cake ball. Set your cake pops in the fridge to chill for dipping. (You can also turn your cake pop upright and set it in your styrofoam block or cake pop stand.)
Dip each chilled cake pop straight down into the melted coating until the cake ball is completely covered and sealed. If you need to angle the cake pop, gently tilt it in one direction and then another. Resist the temptation to stir the coating with the cake pop. If you do, your cake pop may fall off of the stick into a candy coating abyss.
Remove the cake pop from the melted coating by pulling it straight up. Then, turn the cake pop at an angle and gently tap off any excess coating. Don’t get fancy, keep it simple.
Helpful Hint: A tall narrow bowl works best for dipping cake pops. Keeping the coating warm throughout the entire dipping process is key to having a smooth coating on your cake pops. To avoid having to repeatedly reheat your coating, a chocolate melting pot is a great tool.
Set your cake pops in your cake pop stand until the coating has hardened. Or while the coating is still wet use sprinkles, candies, or sugars to decorate your cake pops.
How To Make Cake Pops
sugarkissed.net
Ingredients and Supplies
– A box cake mix and ingredients to make the cake
– A can of frosting
– Candy melts
– Lollipop sticks
– Cake pop stand
Directions
1. Follow the directions on a box of cake mix with one exception: use only half the amount of oil.
2. Let the baked cake cool completely. Then, crumble the cake into fine crumbs using your hands or a food processor.
3. Add a small amount of frosting to your cake crumbs and thoroughly combine using your hands. Continue to add small amounts of frosting until your crumb mixture becomes the consistency of clay.
4. Roll the cake mixture into balls about 1.25″ wide.
5. Set your cake balls onto a parchment lined baking sheet or plate and put them in the freezer or refrigerator until chilled.
6. Microwave your candy melts in a bowl on low power for 30-seconds at a time. Stop and stir after each 30-second interval then repeat until the coating is completely melted.
7. Dip the end of a lollipop stick into the melted coating and then into a cake ball, gently pushing until the stick is about half way through the cake ball. Turn your cake pop upright and set it in your styrofoam block or cake pop stand.
8. Set the cake pops in the fridge to chill for dipping.
9. Dip each chilled cake pop straight down into the melted coating until the cake ball is completely covered and sealed. Remove the cake pop from the melted coating by pulling it straight up. Then, turn the cake pop at an angle and gently tap off any excess coating. Turn the cake pop upright.
10. Set your cake pops in your styrofoam block or cake pop stand until the coating has hardened. Or while the coating is still wet use sprinkles, candies, or sugars to decorate your cake pops.
That’s where this cake pop how to ends and another begins…
If you’re looking for inspiration for how to decorate cake pops, browse through my Cake Pop Gallery.
For endless cake pop recipe ideas, check out How To Make Cake Pops with Unique Flavors.
To show off your stylish cake pops, learn how to take amazing cake pop photos!
Can you add food coloring to the candy melts to make them a different colors?
Nicole, yes, just make sure you are using candy coloring. Regular gel coloring will cause the chocolate to seize up.
love it!! i’ll try it for my son’s bday! how many days before the D-day can I do them? should I put them in the fridge once they are finished? or just in a dry room??
thanks!
Romi, I would make them only a couple days in advance unless you are freezing them. No need to refrigerate if they are completely sealed in chocolate.
Pingback: Step by step how to make cake pops recipe and tutorial- Note the dipping stick into candy coating before you put it into the cake ball. - All Foods Drinks
I just made some cake pops using this method today and love them! I’m giving some to my bridesmaids, but one of them lives hundreds of miles away so will have to mail hers. Would they be ok for two or three days with no refrigeration?
Hi, Amy. I have never shipping cake pops myself. They are okay out on the counter for a few days. My only concern with shipping them is that it’s getting warm out. Check out this great post by Cake Pop Princess with step-by-step directions for shipping cake pops: http://thecakepopprincess.blogspot.com/2012/04/how-to-ship-post-cake-pops-cake-pop.html
Pingback: Cherry Cheesecake Cake Pops + Cupcakery Giveaway
Hello, I really love this method. I have one question, what cake mix or brand will you recommend? I was told that some cake mixes are to moist to make cake pops. Please help if you can, thanks so much!
You can use any brand. You might need to adjust the amount of frosting you add depending on how moist the cake is to reach the clay-like consistency. Add little by little frosting to get to the clay consistency of the cake pops.
Shannon, I typically use Duncan Hines cake mix. If you find that your cake is really moist, just cut back on the frosting to compensate.
I was just wondering why we use 1/2 the amount of oil. I’m planning to make these so I am searching for recipes and other recipes don’t half the oil. Does it change the consistency for making cake pops?
Hi, Karis. I like to cut the oil in half to prevent the cake pops from leaking oil. If you do not cut the oil in half, you will probably need to compensate by using less frosting.
Thank you so much for answering!
This is my 1st time making cake pops and I have researched many different recipes and sites for proper direction and this site seems to be the most easiest to understand and do!!! I followed every direction to the t!!!! Thanks!!!
DO YOU BAKE THIS ANY?
Karen the only thing you bake is the cake that’s it. Follow the directions of the cake mix except when adding oil use 1/2 of what it asks for. Let the cake cool completely. That’s all you have to bake.
Does the type of frosting matter when making cake balls? I like the fluffy white frosting, also known as 7 minute frosting, as it is not as sweet as ready-made frosting.
Can I bake the cake a week before making the pops and store it in a container?
Im.going to try this
how to make a frosting for a cake pop?